PE Protective Film Designed For Wood Floor

1. Soft Material: Made of high-density polyethylene (PE), it has a certain thickness and toughness to cushion impacts.

2. Moderate Adhesion: The adhesive layer is formulated with a special recipe, ensuring firm adhesion while being easy to peel off. It leaves no adhesive residue and will not damage the floor finish.

3. Anti-slip Surface: The top surface is usually equipped with anti-slip textures, which prevent workers from slipping while walking on it and also stop light objects from sliding.

4. Waterproof and Dustproof: Effectively protects floors from contamination by paint, coatings, cement mortar, dust and other substances.

1. Floor Cleaning: Thoroughly clean and completely dry the floor before application; any sand particles may scratch the floor surface.

2. Adhesive Testing: Stick a small piece of the film in a corner or inconspicuous area, peel it off after 24 hours, and check for adhesive residue or floor finish damage.

3. Unidirectional Application: Start from one end of the room and lay the film in a single direction, with an overlap of 5–10 cm between adjacent sheets.

4. Edge Pressing: For self-adhesive types in particular, use a squeegee or hand to smooth the film, expel air bubbles, and ensure tight adhesion of the edges to prevent water seepage.

5. Seam Treatment: For masking tape-attached types, ensure the masking tape is firmly bonded; for heavy-load areas, reinforce the seams with wide adhesive tape.

6. Removal Tips: Remove the film as soon as possible after construction. Peel it off slowly at a 180-degree flat angle in one direction to avoid rapid vertical pulling.